Components for Pre-twisted overhang clamp
Aluminum splint: pressure cast from corrosion-resistant aluminum alloy,Good atmospheric corrosion resistance,And has good mechanical properties.
Rubber fixture: composed of high quality rubber and center reinforcement,With ozone resistance, chemical resistance, weathering resistance,With high and low temperature performance,And higher strength and elasticity,Small compression deformation.
Power standard parts: bolts, spring washers, flat washers, nuts, closed pins, etc.
Pre-twisted wire: aluminum alloy wire customized according to the predetermined mechanical properties and chemical composition, with high tensile strength, hardness and good elasticity and strong anti-rust ability, can be used in harsh climate environment for a long time.
Outer prestrand: same as the prestrand of the protective wire.
Connecting fittings: U-shaped hanging ring, U-shaped screw, UB hanging plate, ZH hanging ring, all are power standard parts.
Pre-twisted overhang clamp use guide
1. The single overhanging clamp can be used for connecting the cable with the straight pole or the pole with the Angle/elevation ≤25°; The double-supported pendant clamp can be used for the linear pole tower with large span or high tilt (tilt) Angle. One set per tower.
2. The hanging cable clips are selected according to the cable outer diameter and spacing/comprehensive load.
3. Suitable for OPGW cable.
4. According to the different methods of hanging wires on the tower, different connecting fittings and hanging wire clips can be selected.
Hot Tags: pre-twisted overhang clamp, China pre-twisted overhang clamp manufacturers, factory, Overhead Tensioning Clamp, Cable Prestranded Overhang Clamp, Sling Hoop, Lead Fittings, Cable Tray Holder, Pendant Single Prestranded Wire Clamp
