The general ADSS tray holder is mainly used to place the spare cables when ADSS/OPGW optical cables are connected. It is divided into two types of rod and tower, and each type of residual cable frame has its specific application scenarios and characteristics.

Residual cable rack for pole

Application scenario: It is suitable for cement or wooden poles in power lines.

Features

The product is treated by hot dip galvanizing and has good outdoor anti-corrosion performance.

According to the requirements of different optical cables, the products to ensure the small bending radius of the optical cable are designed.

Convenient tower installation, can prevent the cable loose, disorder, firm installation and can protect the cable well, avoid optical cable wear.

Cable rest for tower

Application scenario: Applicable to iron towers or steel towers.

Features

It is also made of high strength hot dip galvanized flat steel, which is resistant to corrosion and oxidation.

A clamping bracket is included for easy fixing to the tower Angle steel.

Installation instructions

Preparation stage:

Make sure you provide information about the diameter of the cement pole.

The special fixture for the cable frame is fixed in the proper position on the inside of the tower.

Installation process:

The residual cable is tightly wound on the residual cable rack, and the fixed points are not less than 4.

Fix the residual cable frame in a suitable position, and fix the leads other than the residual cable with the lead down clamp to avoid the phenomenon of wind swing.

Procedure for installing residual cable trays for towers

Preparation stage:

Make sure you provide information about the tower angles.

The cable rest is fixed on the Angle steel of the tower by right Angle splints.

Installation process:

The residual cable is tightly wound on the residual cable rack, and the fixed points are not less than 4.

Fix the residual cable frame in a suitable position, and fix the leads other than the residual cable with the lead down clamp to avoid the phenomenon of wind swing.

Matters needing attention

During the installation process, ensure that the cable rest and its fixing clamp are provided by the manufacturer to ensure quality and insulation performance.

The installation position of the connection box should be more than 1m higher than the remaining cable frame to facilitate OPGW access.

Based on the above information, you can better understand the installation method and importance of ADSS optical cable reframe to ensure the safe and stable operation of optical cables.